Pixel Papercraft

Jumping Magma Cube

Design by xillionpro

Uploaded Sat Jul 27 2013 08:34:03 GMT+0000 (UTC)

92 Login to vote!

Viewed 564 times in the past month
Viewed 110067 times overall

Jumping Magma Cube: when magma cubes jump, they separate into 8 parts revealing a lava inside. This paper craft has all eight separating parts and the lava core. It has cut out sections to put the lava core inside. I cut the sections out with an X-acto knife. You need to make the sections a little bit bigger than they are shown, otherwise the lava core will not fit. To make a stand: I put holes in one corner of each piece, with a pin, then put the wire through the holes, gluing the parts to the wire with a hot glue gun as I went. Use the numbers to know in what order to put the parts in. Please comment your questions and concerns.

How to Print?

  1. Click on the papercraft design image.

  2. Make sure it has not been resized by your browser (you might need to click the image again).

  3. Print using your browser's Print function.

If you leave a comment, be respectful.

No swearing, including censored or abbreviations.