📝Instructions for better printing quality: Click on the Google Drive link, the 9 sheets will appear. Click on the printer at one end, a viewer will open. Click on the printer, the display will appear, click where the blue "Print" button is displayed and that's it (If you want without instructions, in the same display where it says Pages, put 7 sheets and that's it. It prints much better).

🧠-Remember that 1 sheet, which is the water sheet, prints on transparent sheet.

-Note: When you press Control + P on a PC, it will show the display, but it will print with lower quality.

-If you are over 13 years old ( (Over 13) Use superglue to glue the tree and the wooden supports.

-If you are under 13 (<13), use superglue with adult supervision.

🛡️-If you want a more resistant surface, use 200g A4 paper.

-For the terrain,🏠 so it doesn't bend or the 🌳tree leans to one side, use A4 cardboard. Use a pencil to measure it and a box cutter🪚 to cut it out. Finally, glue the terrain onto the cardboard with liquid silicone.

Note: When you glue with glue, the terrain may rise, forming hills at the edges or making the terrain darker and weaker. So, if you use glue, put a thin layer of glue on top to prevent this from happening.

Note (Optional): If you want to make the surface of the well more resistant: cut A4 cardboard with a box cutter (only if you are under 13, use with adult supervision). The measurements are 1.6cm wide. 1.6 cm tall (16 mm).

Note: If you print at 105% scale, the measurements are 16.8 mm.